1. Introduction
Msoen spraying drones are designed for efficient agricultural pesticide spraying, fertilizer spreading, and precision farming operations.
This guide explains the complete operating process from preparation to post-operation cleaning, ensuring safe and efficient field performance.
2. Pre-Operation Preparation
Before starting any spraying mission, ensure the following checks are completed:
- Battery is fully charged (above 95%)
- Spray tank is clean and properly installed
- Liquid pesticide or fertilizer is correctly mixed
- Nozzles are not blocked or damaged
- GPS signal is stable (recommended 10+ satellites)
- Flight area is clear of people, animals, and obstacles
Proper preparation ensures accurate spraying and safe operation.
3. Spray System Setup
Step 1: Fill the Tank
- Use proper chemical dilution ratio according to crop requirements
- Avoid overfilling beyond maximum tank capacity
Step 2: Check Nozzles
- Ensure all spray nozzles are clean
- Replace damaged nozzles immediately
Step 3: Activate Spray System in App
- Open Msoen control application
- Select “Spray Mode”
- Adjust flow rate based on field requirements
4. Flight Path Planning
Step 1: Field Mapping
Use the app to scan or manually draw the farmland boundary.
Step 2: Set Parameters
- Flight height (recommended 2–5 meters above crops)
- Spray width
- Flight speed
- Overlap rate for even coverage
Step 3: Save Route
Once configured, save the route for automatic operation.
5. Automatic Spraying Operation
Step 1: Start Mission
- Move drone to takeoff position
- Perform system check
- Press “Start Mission” in the app
Step 2: Automatic Execution
The drone will:
- Take off automatically
- Follow pre-set route
- Spray evenly across the field
Step 3: Real-Time Monitoring
Monitor:
- Battery level
- Spray volume
- Flight stability
6. Post-Operation Cleaning
Proper cleaning is essential for long-term system performance:
- Empty remaining liquid from tank
- Flush spray system with clean water
- Clean nozzles carefully
- Dry all components before storage
7. Safety Guidelines During Spraying
- Do not allow people or animals in operating area
- Avoid spraying in strong wind conditions
- Do not operate near water sources unless approved
- Always wear protective equipment when handling chemicals
FAQ
Q1: Why is spraying uneven?
A: Usually caused by clogged nozzles or incorrect flow settings.
Q2: Can I use the drone in windy conditions?
A: It is not recommended. Wind affects spray accuracy.
Q3: How accurate is automatic spraying?
A: Accuracy depends on GPS signal strength and route planning.
Q4: What chemicals can I use?
A: Only approved agricultural pesticides or fertilizers suitable for aerial spraying.
No comments yet